Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Aprilia Rs 660
Part: Engine oil

To change the oil in your Aprilia RS 660, follow these steps. First, slightly warm up the engine to make the oil more fluid. Place the motorcycle on a central stand for stability. Locate the oil drain plug on the lower side of the engine. Use a suitable wrench to loosen the plug and let the used oil drain completely into a collection container. Once all the oil has drained, tighten the drain plug securely. Next, locate the oil fill plug, usually located on the side of the engine. Remove the plug and slowly pour the recommended amount of new motor oil, following the owner's manual specifications for viscosity and quantity. Make sure not to exceed the maximum level indicated on the oil level dipstick. After filling, tighten the fill plug securely. Start the engine for a few minutes and check for any oil leaks. Check the oil level using the dipstick and add oil if necessary. Finally, dispose of the used oil properly at an authorized collection center.

Posted on 13 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil and Oil Filter of the Aprilia RS 660
Rs 660 In this brief and simple guide, you will learn how to replace the engine oil and oil filter of the Aprilia RS 660 motorcycle. First, lift the motorcy…
How to change the motor oil of an Aprilia RS 660?
Rs 660 To change the motor oil of an Aprilia RS 660, start by lifting the motorcycle and placing it on a stable support. Remove the oil filler cap, located …
How to Change the Engine Oil on an Aprilia RS 660
How to Change the Engine Oil on an Aprilia RS 660
Rs 660 Start by placing your Aprilia RS 660 on the central stand. Next, turn on the engine and let it idle. After a couple of minutes, turn off the engine a…

How to Reset the Service on the Husqvarna FE 350?

In this tutorial, you will see how to reset the service on the Husqvarna FE 350, a very simple and quick operation. Before proceeding, ensure you have completed all required scheduled maintenance tasks. Start by inserting the key and turning on the instrument panel; it is not necessary to start the engine. Then, repeatedly press the button located to the right of the display until you reach the odometer reading "ODO". Once done, press and hold the opposite button for about 5 seconds, and when the screen changes, press the right button again.

Watch the video!


by ScegliAuto

More videos