Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Aprilia Rs 660
Part: Brake pads

In this guide, we will discover the instructions on how to disassemble and replace the rear brake pads on an Aprilia RS 660. First, place the motorcycle on the stand and start by removing the central pin of the brake caliper; unscrew the two fastening screws of the caliper to remove it, as shown in the video. At this point, remove the old brake pads, cleaning the caliper of any residual dirt; install the new original brake pads, properly securing the brake caliper onto the disc and inserting the locking pin for the rear brake pads.

Posted on 16 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads on an Aprilia RS 660
How to Replace the Front Brake Pads on an Aprilia RS 660
Rs 660 To replace the front brake pads on an Aprilia RS 660, loosen the bolts that secure the brake caliper to the front wheel disc. Once the bolts are loos…
How to replace the front brake pads on the Aprilia RS 660?
How to replace the front brake pads on the Aprilia RS 660?
Rs 660 To replace the front brake pads on the Aprilia RS 660, loosen the screws that secure the brake caliper to the front wheel disc. Once the screws are r…
How do you replace the engine oil of the Aprilia RS 660?
How do you replace the engine oil of the Aprilia RS 660?
Rs 660 It will be possible to perform the oil change of the Aprilia RS 660 by unscrewing the oil cap located in the central lower part of the vehicle: once …

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos