Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today, learn how to remove the clutch cover of an Aprilia Shiver 750 by following these simple instructions. After placing the bike on a stand, obtain a socket spanner to undo the screws of the clutch cover; then remove it, taking off the gasket around it. At this point, you will have access to the clutch pack, where you will undo the fixing screws to remove and replace the discs if necessary. It is crucial to install the new gasket on the clutch cover before refitting it!

Updated on 25 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replace the Coolant in the Aprilia Shiver 750
Replace the Coolant in the Aprilia Shiver 750
Shiver 750 In this short and simple guide, follow the steps to replace the coolant in the Aprilia Shiver 750. First, place the bike on its stand and start remov…
How to Replace the Coolant in the Aprilia Shiver 750?
How to Replace the Coolant in the Aprilia Shiver 750?
Shiver 750 To replace the coolant in the Aprilia Shiver 750, position a container under the drain hose to collect the old fluid. The hose must be disconnected f…
How to Bleed the Cooling System of the Aprilia Shiver 750
How to Bleed the Cooling System of the Aprilia Shiver 750
Shiver 750 In this guide, you will learn the steps necessary to bleed the cooling system of the Aprilia Shiver 750 motorcycle. First, place the bike on its stan…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos