|
Do it yourself
| |||
| ||||
Replace the Coolant in the Aprilia Shiver 750
Model: Aprilia Shiver 750
Video tutorial
In this short and simple guide, follow the steps to replace the coolant in the Aprilia Shiver 750. First, place the bike on its stand and start removing the right side fairing by unscrewing the screws; then disconnect the hose located on the pump casing, allowing the fluid to drain into a container for about ten minutes, as shown in the video. At this point, unscrew the cap of the coolant reservoir and top up, filling to the maximum level mark!
Updated on 25 June 2026 by ScegliAuto
Related tutorials
Shiver 750
.. To replace the coolant in the Aprilia Shiver 750, position a container under the drain hose to collect the.. …
Shiver 750
In this guide, you will learn the steps necessary to bleed the cooling system of the Aprilia Shiver 750 motorcycle. First, place the bike on its stan…
Shiver 750
You can replace the rear brake pads on the Aprilia Shiver 750 by removing the safety clip and unscrewing the pin that holds the pads in place. It is …
|
How to remove the seat on a Yamaha Tracer 9 GT?
In this tutorial, you can see how to remove the seat on a Yamaha Tracer 9 GT, a very simple and quick operation, for example, if you need to access the battery. First, remove the passenger seat by inserting the key into the designated lock, then locate the indicated rubber element and remove it by pulling it outwards. Next, insert your hand into the indicated gap, hold down the release lever, and simultaneously detach the seat from the support. To reassemble everything, simply follow the reverse procedure. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
