Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Service on Aprilia Shiver 750

Model: Aprilia Shiver 750
Part: Engine oil

This video is currently unavailable

It is recommended to use synthetic engine oil 10W-40 for this model. After starting the engine for a few minutes, remove the bolt located under the engine compartment using a ratchet spanner.

While collecting the used oil in a container, unscrew the filter (by hand if you have enough strength, otherwise use a pipe wrench). Remove the oil filter, lubricate the O-ring of the new filter (you can use the used oil), insert it, and screw it on. Close the lower drain hole when all the oil has drained, and fill the same quantity of the recommended lubricant through the upper hole, as shown in the video.


Updated on 26 April 2026 by ScegliAuto


Related tutorials

Replace the Coolant in the Aprilia Shiver 750
Replace the Coolant in the Aprilia Shiver 750
Shiver 750 In this short and simple guide, follow the steps to replace the coolant in the Aprilia Shiver 750. First, place the bike on its stand and start remov…
How to Bleed the Cooling System of the Aprilia Shiver 750
How to Bleed the Cooling System of the Aprilia Shiver 750
Shiver 750 In this guide, you will learn the steps necessary to bleed the cooling system of the Aprilia Shiver 750 motorcycle. First, place the bike on its stan…
How to Replace the Rear Brake Pads on the Aprilia Shiver 750?
How to Replace the Rear Brake Pads on the Aprilia Shiver 750?
Shiver 750 You can replace the rear brake pads on the Aprilia Shiver 750 by removing the safety clip and unscrewing the pin that holds the pads in place. It is …

How to Replace the Front Headlamp Bulb on the Royal Enfield Classic 350?

Replacing the front headlamp bulb on the Royal Enfield Classic 350, as shown in this tutorial, is an extremely simple and quick operation. Before proceeding, ensure that the key is not inserted for safety. Start by going to the front of the headlamp, then locate and unscrew the two screws on either side. Next, separate the lamp from the base, disconnect the power connector, and remove the rear rubber cover. To extract the bulb from the housing, simply unlock the metal clip, and follow the reverse procedure to reassemble everything.

Watch the video!


by ScegliAuto

More videos