Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Spark Plug on an Aprilia SR 50

Model: Aprilia Sr 150
Part: Spark plugs

Video tutorial

In this video, you will see how to remove and replace the spark plug on an Aprilia SR 150 scooter in simple and quick steps. First, open and lift the seat of your scooter and unscrew the fixing screws of the storage compartment to remove it; then remove the spark plug cap, as shown in the video.

At this point, use a socket wrench with an extension to unscrew and replace the spark plug with the correct type and thermal rating; now hand-tighten the new one and finally tighten it with the wrench, reassembling everything!


Updated on 3 May 2026 by ScegliAuto


Related tutorials

How to Change the Gear Oil on the Aprilia SR 150?
How to Change the Gear Oil on the Aprilia SR 150?
Sr 150 To change the gear oil on the Aprilia SR 150, loosen the drain plug located at the rear of the transmission casing: there will be two, and in this ca…
How to Change the Engine Oil of the Aprilia SR 150?
How to Change the Engine Oil of the Aprilia SR 150?
Sr 150 To change the engine oil of the Aprilia SR 150, loosen the drain plug located at the bottom of the bike. Once it is loosened, collect the used oil in…
How to Change the Engine Oil on an Aprilia SR 150
How to Change the Engine Oil on an Aprilia SR 150
Sr 150 To change the engine oil on an Aprilia SR 150, start by warming up the engine for a few minutes to make the oil more fluid, then turn it off. Positio…

How to Replace Engine Oil in the Husqvarna TE 610?

In this tutorial, you will see how to replace the engine oil in the Husqvarna TE 610, a very simple and quick operation. Before proceeding, wait for the engine to cool completely to operate safely. Start by removing the lower protection panel, then locate the drain bolt on the right side and loosen it using a 14 mm socket spanner. Once all the oil has drained from the system, remove the filter, clean it of any dirt residue, and reassemble everything. Finally, insert the required amount of oil through the upper hole.

Watch the video!


by ScegliAuto

More videos