Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video tutorial, you will learn how to replace the gearbox oil on the Aprilia Rx 50 2-stroke enduro bike by following these simple and quick steps. First, place your bike on a stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes. Next, remove the screws from the oil filter cover and replace the cartridge with a new one. At this point, unscrew the oil filler bolt, top up the oil, and finally check the gearbox oil level!

Updated on 23 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Warning Light on the Aprilia Rx 50
How to Reset the Warning Light on the Aprilia Rx 50
Rx 50 In this new mini guide dedicated to your Aprilia Rx 50, discover how to reset the service light. First, locate the button on the right side of the da…
How to Replace the Clutch on an Aprilia RX 50
How to Replace the Clutch on an Aprilia RX 50
Rx 50 Today, we will see how to disassemble and replace the clutch plates on an Aprilia RX 50, following the instructions below. First, place your bike on …

Guide to replacing the starter motor of the Piaggio Vespa ET4 150

Today's guide will show us how to disassemble and replace the starter motor of the Piaggio Vespa ET4 150 scooter, in simple steps. First, we put the scooter on the center stand and lift the seat; we remove the battery, disconnecting both terminals, and then remove the compartment under the seat, as shown in the video. At this point, we disconnect the intake hose to access the starter motor, unscrewing its fastening screws and disconnecting the wiring to remove it; all that's left is to replace it with the new original one, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos