Do it yourself
| ||||
|
Model: Aprilia Shiver
In order to replace the rear light bulb of the Aprilia Shiver you have to go and remove the fairing of the rear part of the bike, immediately behind the saddle. Once this has been removed, it will be necessary to unscrew the screws below, so that the rear light can be moved and the bulbs inside it extracted. Once they have been removed, they will need to be disconnected from their connector and replaced with a new spare part. After replacing the bulbs, you will need to fix the headlight again with the screws and cover them with the rear fairing.
Posted on 21 June 2022 by ScegliAuto
|
How do you change the Benelli 502C engine oil?In order to replace the Benelli 502C engine oil, you need to unscrew the oil drain plug which is positioned in the lower left part of the bike. Once this cap has been opened, it will be possible to collect the used oil in a suitably positioned container: when all the oil has completely flowed out, it will be possible to go and extract the oil filter placed in the same area. , so that it is replaced with a new spare part. Finally, it will then be possible to top up from the special vent on the right side of the bike. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.005
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |