Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Aprilia Shiver - Video guides

Aprilia Shiver
Service Light Reset on an Aprilia Shiver
To reset the service light on an Aprilia Shiver, use the lever on the left side of the handlebars to enter the menu displayed on the screen. Select the …Read all…
Posted on 16 April 2026 by ScegliAuto
Aprilia Shiver
How to Replace the Air Filter on an Aprilia Shiver
To replace the air filter on an Aprilia Shiver, you need to loosen the screws that secure the seat to its housing, completely removing it to access the screws …Read all…
Posted on 27 August 2026 by ScegliAuto
Aprilia Shiver
How to change the engine oil on an Aprilia Shiver?
To change the engine oil on an Aprilia Shiver, unscrew the oil drain plug located on the lower side of the bike so that all the used oil can drain out into a …Read all…
Posted on 9 August 2026 by ScegliAuto
Aprilia Shiver
How to Replace the Rear Wheel of the Aprilia Shiver?
To replace the rear wheel of the Aprilia Shiver, you need to loosen the central nut that secures the rear axle to the corresponding swingarm. Once the nut is …Read all…
Posted on 6 November 2026 by ScegliAuto
Aprilia Shiver
How to Replace the Exhaust on the Aprilia Shiver
To replace the exhaust on the Aprilia Shiver, lift the rear part of the seat to gain access to the components underneath: this will allow access to the screws …Read all…
Posted on 14 October 2026 by ScegliAuto
Aprilia Shiver
How to Replace the Lambda Sensor on an Aprilia Shiver?
To replace the lambda sensor on an Aprilia Shiver, first disconnect the connector related to it, which is located on the right side of the bike. Once the …Read all…
Posted on 2 September 2026 by ScegliAuto
Aprilia Shiver
How to Perform a Service on an Aprilia Shiver
Today, let's look at the guide that will allow you to perform the routine maintenance service, replacing the engine oil and oil filter on the Aprilia Shiver …Read all…
Posted on 31 July 2026 by ScegliAuto
Aprilia Shiver
How to Replace the Rear Bulb on an Aprilia Shiver?
To replace the rear bulb on an Aprilia Shiver, you need to remove the fairing from the rear of the motorcycle, just behind the seat. Once this is removed, …Read all…
Posted on 29 July 2026 by ScegliAuto
Aprilia Shiver
How to Replace the Battery in an Aprilia Shiver
To replace the battery in an Aprilia Shiver, access the underside of the seat by unscrewing the screws that secure it on the sides. Once these screws are …Read all…
Posted on 8 July 2026 by ScegliAuto
Aprilia Shiver
How to Change the Engine Oil on an Aprilia Shiver
It is advisable to perform this operation with the engine slightly warm. Start by placing your Aprilia Shiver on a motorcycle stand. Next, unscrew the lower …Read all…
Posted on 31 May 2026 by ScegliAuto
Aprilia Shiver
Replacing the Front Headlight Bulb on an Aprilia Shiver 750
In this video tutorial, you will learn how to dismantle and replace the front headlight bulb on an Aprilia Shiver 750. First, remove the hex screws located on …Read all…
Posted on 1 May 2026 by ScegliAuto
Aprilia Shiver
How to Change Oil and Oil Filter on Aprilia Dorsoduro/Shiver 750 ABS
Start the engine for a couple of minutes before beginning the work. This will make the oil warmer and therefore less viscous, but do not leave the bike running …Read all…
Posted on 25 April 2026 by ScegliAuto

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos