Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Engine Oil and Oil Filter on an Aprilia RSV4 1000

Model: Aprilia Rsv4 1000
Part: Engine oil

Video tutorial

Today, we will discover the instructions that will allow you to remove and replace the engine oil and oil filter on an Aprilia RSV4 1000 motorcycle. First, place your motorcycle on a stand and start removing the lower engine fairing by unscrewing the screws; then, unscrew the drain bolt located on the sump, allowing the oil to drain into a container for about ten minutes, as shown in the video.

At this point, unscrew the oil filter cartridge, located behind the small radiator; install the new oil filter and finally top up with the new oil!


Updated on 25 June 2026 by ScegliAuto


Related tutorials

How to change the engine oil on the Aprilia RSV4 1000?
How to change the engine oil on the Aprilia RSV4 1000?
Rsv4 1000 To change the engine oil on the Aprilia RSV4 1000, loosen the screws securing the panel located at the bottom of the bike, also removing the one on t…
How to replace the engine oil and oil filter of the Aprilia RSV4 1000 Factory
How to replace the engine oil and oil filter of the Aprilia RSV4 1000 Factory
Rsv4 1000 In this guide, we will see the main instructions on how to perform the routine maintenance service, replacing the engine oil and oil filter, of the A…
How to Change the Engine Oil on the Aprilia RSV4 1000
How to Change the Engine Oil on the Aprilia RSV4 1000
Rsv4 1000 This guide explains how to replace the engine oil and oil filter during the regular maintenance service on the Aprilia RSV4 1000. First, remove the l…

How to Replace the Belt and Rollers on the Piaggio Vespa GTS 300

This guide briefly outlines the steps to remove and replace the belt and rollers of the variator on the Piaggio Vespa GTS 300 scooter, following the instructions below. First, place your scooter on the centre stand and begin unscrewing the screws of the transmission cover to remove it; then unscrew the nut of the fan and that of the clutch bell, as shown in the video. At this point, remove the belt and then the variator, replacing the rollers found inside; install the new belt and reassemble the transmission!

Watch the video!


by ScegliAuto

More videos