Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the engine oil and oil filter on the Aprilia Leonardo

Model: Aprilia Leonardo
Part: Engine oil

Video tutorial

To ensure the proper functioning of the engine and its longevity, it is necessary to regularly replace the engine oil and oil filter; let’s see how to perform the service on the Aprilia Leonardo 125 scooter. First, place the scooter on its centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then remove the small oil filter cartridge, replacing it with a new one, as shown in the video.

Finally, pour the oil into the fill hole!


Updated on 19 August 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil on an Aprilia Leonardo
How to Change the Engine Oil on an Aprilia Leonardo
Leonardo This guide outlines the steps to perform routine maintenance by changing the engine oil on an Aprilia Leonardo scooter. First, place the scooter on i…
How to Replace the Drive Belt on the Aprilia Leonardo 125
How to Replace the Drive Belt on the Aprilia Leonardo 125
Leonardo In today's tutorial video, you will see the instructions to dismantle and replace the drive belt on the Aprilia Leonardo 125 scooter. First, place yo…
How to Replace the Water Pump on the Aprilia Leonardo 150
How to Replace the Water Pump on the Aprilia Leonardo 150
Leonardo Below is the guide and instructions needed to remove and replace the rear wheel and rear brake disc on the Aprilia Leonardo 150 scooter. First, place…

How to Replace the O-ring on the Clutch Rod of the LML Star?

To replace the O-ring on the clutch rod of the LML Star, lift the bike to loosen the side panel located near the rear wheel. Next, unscrew all the screws securing the rear wheel and the corresponding transmission cover: by removing the clutch, you will be able to locate the rod positioned behind it. This rod can now be removed from its housing by unscrewing the fastening screws; after the old rod has been removed, slide out the O-ring, replace it with a new one, and reassemble all previously removed components.

Watch the video!


by ScegliAuto

More videos