Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the License Plate Light on an Audi TT

Model: Audi Tt MK 2, 8J - Years 2006-2014
Part: Instrument panel light

Replacing the license plate light on an Audi TT? Let's see in this video how to replace the damaged bulb. Open the trunk hood, and using a screwdriver or plastic trim tool, remove the plastic light fixture located in the rear hatch of the vehicle. Once the light fixture is removed, pull out the bulb holder with your fingers, then remove the bulb from it. Install the new bulb (same size and voltage) into the bulb holder, and reattach the light fixture to the rear hatch. Finally, test the proper operation of the previously installed bulb.

Updated on 28 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Where Are the Fuses Located in the Audi TT?
Where Are the Fuses Located in the Audi TT?
Audi Tt (1998-2006 / 8N, MK 1) The fuses in the Audi TT are located inside the fuse boxes installed in the vehicle: this car model has two fuse boxes. The first is located on the s…
How to Replace the Reverse Light Bulbs in an Audi TT?
How to Replace the Reverse Light Bulbs in an Audi TT?
Audi Tt (1998-2006 / 8N, MK 1) In this tutorial, you will see how to replace the reverse light bulbs in an Audi TT, a very simple and quick operation. First, ensure the key is not …
How to open the trunk of the Audi TT
How to open the trunk of the Audi TT
Audi Tt (2006-2014 / MK 2, 8J) The trunk of the Audi TT can only be opened when the car is unlocked, on these models it is in fact impossible to open the hood, trunk, or fuel door …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos