Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Third Brake Light on an Audi TT

Model: Audi Tt 8J, MK 2 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Part:

See other generations:
Video tutorial

Before you begin, open the trunk of your Audi TT. Using a flathead screwdriver, pry off the lock cover of the trunk. Next, remove the screws securing the trunk panel, then take off the panel itself.

This will give you access to the screws holding the third brake light. Disconnect the connector, then unscrew and remove the screws mentioned earlier to free the third brake light.

At this point, you can unclip and remove the third brake light, completing the disassembly. To install the new third brake light and close the trunk, simply follow this procedure in reverse, and the replacement will be complete.


Updated on 3 April 2026 by ScegliAuto


Related tutorials

Replacing the Rear Brake Pads and Rotor on an Audi TT
Replacing the Rear Brake Pads and Rotor on an Audi TT
Audi Tt (1998-2006 / MK 1, 8N) Today's guide will show you how to remove and replace the rear brake pads and rotor on an Audi TT by following these simple steps. First, lift the ve…
How to replace the rear headlight bulb of the Audi TT
How to replace the rear headlight bulb of the Audi TT
Audi Tt (2006-2014 / 8J, MK 2) Replacing the brake light bulb or the rear headlight bulb on the Audi TT is a simple and quick operation to be carried out independently. To replace …
Replacing Rear Brake Pads
Replacing Rear Brake Pads
Audi Tt (2006-2014 / 8J, MK 2) Lift the vehicle on appropriate jack stands and remove the rear wheel; then unscrew the retaining bolts of the brake caliper to remove it; next, take…

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos