Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the sun visor clip for the Audi A3.

Model: Audi A3 MK 2, 8P - Years 2003-2013

In this guide we will see the instructions that will allow us to disassemble and replace the sun visor of the Audi A3, in simple and quick steps. First of all, we get on board the car and start to detach the sun visor from the clip side; then we detach the clip from the roof lining using a thin plastic lever, until it is completely removed, as shown in the video. At this point we install the new plastic clip, fixing it correctly; finally, we hook the sun visor and check its correct sliding, following the video tutorial until the end!

Posted on 10 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Repair the Sun Visor of the Audi A3
How to Repair the Sun Visor of the Audi A3
Audi A3 (2003-2013 / MK 2, 8P) In this brief and simple guide, you will learn how to repair the sun visor of the Audi A3, following the instructions below. First, get into the vehi…
How to Remove the Sun Visor from the Audi A3
How to Remove the Sun Visor from the Audi A3
Audi A3 (2003-2013 / MK 2, 8P) In this video tutorial, learn how to remove and replace the sun visors of the Audi A3 by following these simple and quick steps. First, get inside th…
How to change the sun visor of the Audi A3 8V
How to change the sun visor of the Audi A3 8V
Audi A3 (2012-2019 / 8V, MK 3) In this video we can see how to change the sun visor of the Audi A3 8V; we first detach the previous one, removing the cover of the hook and then dis…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos