Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A3
    4. : Replacing the low beam on the Audi A3 8p

Audi A3 - Video tutorial

Model: Audi A3 MK 2, 8P - Years 2003-2013
Part: Headlight bulb
Operation: Replacing the low beam on the Audi A3 8p

When working with the engine off and the handbrake applied, raise the hood and stop it safely. Disconnect the connector located behind the headlight concerned, then access the bulb from the rear of the same. Unclip the catch or cover behind the exhausted Xenon bulb and then remove it. Insert the new bulb and reassemble everything obviously proceeding backwards, finally check that it works correctly. If the bulb still does not work, it means that the fuse that takes care of it must also be replaced and that the problem was therefore not the bulb.


Posted on 14 March 2024 by ScegliAuto

    Frequently Asked Questions

    • A3 2003-2013 - How to replace the headlight bulbs in the Audi A3? Read Answer
    • A3 2012-2019 - How to replace the headlight bulb on an Audi A3? Read Answer

How do you adjust the clutch cable on the Kia Picanto?

To be able to adjust the clutch cable of the Kia Picanto you need to open the hood so that you have access to the components inside the engine compartment: in order to reach the cable you will need to remove some components on the right side, such as the battery and the air filter. Below them you will find the clutch cable, which will have to be adjusted by screwing or loosening the bolt placed at the end of the cable. This will make the pedal harder or softer; after the adjustment, it will be possible to assemble all the components by closing the hood.

Watch the video!


by ScegliAuto

More videos