Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A2
    4. : How do I reset the Audi A2 service warning light?

Audi A2 - Video tutorial

Model: Audi A2 MK 1 - Years 1999-2005
Part: Checks and maintenance
Operation: How do I reset the Audi A2 service warning light?

In order to reset the Audi A2 service warning light, press and hold the button on the right of the instrument panel, immediately below the speedometer. Keeping this button pressed, it will be necessary to turn the key to turn on the instrument panel, releasing the button: in this way the message "OK" will appear in the central part of the display. This message indicates that the Service light has been correctly reset; to check that the warning light has been reset correctly, the instrument panel can be switched off and on again by reading the maintenance intervals in the menu.


Posted on 8 April 2024 by ScegliAuto

    Frequently Asked Questions

    • A2 1999-2005 - What problems does the Audi A2 have on ABS? Read Answer
    • A2 1999-2005 - Where is the Audi A2 yaw sensor located? Read Answer
    • A2 1999-2005 - Where is the washer fluid reservoir of an Audi A2 located? Read Answer
    • A2 1999-2005 - What to do when the ABS light comes on on an Audi A2? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos