Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the starter motor on the Audi A3

Model: Audi A3 8P, MK 2 - Years 2003-2013
Part: Starter motor

Let's see in this guide how to disassemble and replace the starter motor of the Audi A3, following these simple instructions. First of all, we open the bonnet of our car and begin to disconnect our battery beforehand, also disconnecting one of the two terminals; after which we remove the air filter box, unscrewing the screws on the sides and removing the suction sleeve, as shown in the video. At this point we unscrew the screws of the starter motor, removing it and replacing it with the new one; we make and connect and reassemble everything!

Posted on 13 October 2022 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the starter motor on the Audi A3?
How do you replace the starter motor on the Audi A3?
Audi A3 (1996-2003 / 8L, MK 1) In order to replace the starter motor of the Audi A3 you have to open the hood in order to access the components inside the engine compartment: here …
How to Replace the Starter Motor on an Audi A3
How to Replace the Starter Motor on an Audi A3
Audi A3 (2003-2013 / 8P, MK 2) Lift the bonnet and remove a terminal from the battery to protect other components. Next, disconnect the connector linked to the air intake and remov…
Replacing the starter motor of the Audi A3 2.0 TDI
Replacing the starter motor of the Audi A3 2.0 TDI
Audi A3 (2003-2013 / 8P, MK 2) Let's briefly see the instructions that will allow us to disassemble and replace the starter motor of the Audi A3 2.0 TDI. First of all, we open the …

Other guides you may be interested in

How to Replace the Front Headlamp Bulb on a Fiat Grande Punto

To replace the front headlamp bulb on a Fiat Grande Punto, first open the bonnet. Once done, access the rear of the headlamp where the bulb needs replacing (the bulb is of type H4). Locate the rubber cover that protects the electrical contacts and bulbs from water and moisture. Remove it by pulling on the tab. Now, pull the connector for the bulb's power supply and disconnect it from its position. At this point, push down on the top of the spring that holds the bulb in place, and you can extract the bulb from its housing. To fit the new bulb, follow the steps in reverse as shown in the images. The video also shows how to remove the position bulb, which is located just below the H4. After disconnecting the power supply, you can extract it along with the bulb holder by pressing the two tabs to release it and pulling. The bulb can then be removed from its position in the bulb holder.

Watch the video!


by ScegliAuto

More videos