Do it yourself
Frequently asked questions about cars and motorcycles

Reverse Light Switch Replacement

Model: Audi A6 C6, MK 3 - Years: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Push button

See other generations:
Video tutorial

The reverse light switch is responsible for turning on the rear lights when the vehicle is put into reverse. It is located on the transmission just above the axle.

To remove it, position the vehicle on a lift or on appropriate jack stands. Once the vehicle is raised, locate the switch, disconnect the connector, and unscrew the switch itself (it is shaped like a bulb).

Then, screw in and tighten the new switch and reconnect the connector. Finally, put the vehicle in reverse and ensure the rear lights illuminate correctly.


Updated on 15 February 2026 by ScegliAuto


Related tutorials

Audi A6 (2004-2012 / C6, MK 3) These brief and simple steps will show you how to remove and replace the reverse light switch on the Audi A6. First, lift the vehicle and locate the …
Audi A6 (2004-2012 / C6, MK 3) The fuses in the Audi A6 are divided among the two fuse boxes installed in the car. In this model, there are two: the first is located on the side of…
Audi A6 (2004-2012 / C6, MK 3) To replace the window switch on an Audi A6, you need to completely remove the corresponding door panel. To do this, loosen the screws under the horiz…

How to Open the Fuel Filler Flap in the Hyundai i30?

In this tutorial, you will learn how to open the fuel filler flap in the Hyundai i30, a very simple operation that follows the typical procedure of most vehicles. First, unlock the locks using the designated button on the remote, then open the driver's door, locate the release lever on the left side of the seat, and operate it. Next, move to the fuel filler flap, open it completely, unscrew the cap, and refuel as needed. To close the flap, simply press it gently.

Watch the video!


by ScegliAuto

More videos