Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Interior Lights of the Audi A4

Model: Audi A4 B6 - Years 2000-2004
Part: Interior dome light bulb

Follow these steps to remove and replace the interior bulbs of the Audi A4. First, get inside the vehicle and start by removing the dome light by prying it from the sides; then disconnect the electrical connector to replace the bulb, as shown in the video. Similarly, remove the lights located below by taking off the housings and replacing the bulbs; use bulbs that have the same base, then snap the housings back into place, following the video tutorial to the end!

Updated on 21 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Headlight Switch of an Audi A4
How to Remove the Headlight Switch of an Audi A4
Audi A4 (2004-2008 / B7) Before starting, sit in the driver's seat of your Audi A4. Begin by pressing and holding the headlight switch. At the same time, rotate it clockwise …
Replacing Interior Lights with LED Lights
Replacing Interior Lights with LED Lights
Audi A4 (2007-2016 / B8) LED lights have undeniable advantages over incandescent bulbs, especially in terms of efficiency and light tone. There are many aftermarket kits avai…
How to Replace the Interior Light Bulbs in an Audi A4?
How to Replace the Interior Light Bulbs in an Audi A4?
Audi A4 (2000-2004 / B6) To replace the interior light bulbs in an Audi A4, use a tool to pry the light assembly from its housing. Once removed, disconnect the connectors and…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos