Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Fuel Filter on an Audi Q5 2.0 TDI

Model: Audi Q5 MK 2, 80A - Years: 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025
Part: Diesel fuel filter

See other generations:
Video tutorial

This guide provides instructions to remove and replace the fuel filter on an Audi Q5 2.0 TDI. First, locate the fuel filter under the vehicle, not usually in the engine compartment; then raise the vehicle and remove the plastic cover under the engine by unscrewing all the fastening screws, as shown in the video.

At this point, disconnect the fuel inlet and outlet lines, removing the filter from the bracket; replace and install the new fuel filter, as well as the original, by applying the reverse procedure!


Updated on 17 September 2026 by ScegliAuto


Related tutorials

How to Replace the Fuel Filter on the Audi Q5
How to Replace the Fuel Filter on the Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) The steps illustrated in this guide will show you how to remove and replace the fuel filter on the Audi Q5. First, move to the side of the vehicle an…
How to Remove the Diesel Fuel Filter from an Audi Q5
How to Remove the Diesel Fuel Filter from an Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) Before you can start, lift the front end of your Audi Q5. Begin by removing the lower cover of the diesel fuel filter by unscrewing and taking out th…
How to Replace the Starter Motor on the Audi Q5 2.0 TDI
How to Replace the Starter Motor on the Audi Q5 2.0 TDI
Audi Q5 (2008-2017 / MK 1, 8R) Below are the instructions for removing and replacing the starter motor on the Audi Q5 2.0 TDI. First, open the trunk and disconnect the battery. Nex…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos