Do it yourself
| ||||
|
Audi A3 - Video tutorial
Model: Audi A3
MK 2, 8P
- Years 2003-2013 Today's instructions will show us how to disassemble and replace the rear bumper of the Audi A3, following these simple steps. First, let's move to the rear and open the trunk; then unscrew all the fixing screws and remove the clips found under the bumper and on both sides of the rear wheel arches, as shown in the video. At this point, gently detach the bumper on the sides until it is completely removed, replacing it if necessary with a new one; reassemble the rear bumper, fixing it correctly on the sides!
Posted on 13 March 2024 by ScegliAuto
Other guides that may interest you |
How to reset the tire pressure warning light on Dacia Sandero?Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.017
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |