Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Radiator and Coolant Hoses on the Benelli TRK 502

Model: Benelli Trk 502

Video tutorial

This guide provides instructions for replacing the radiator and engine coolant hoses on the Benelli TRK 502 motorcycle. First, place the motorcycle on the stand and start disconnecting the coolant hoses connected to the radiator by loosening the metal clip screw; then disconnect the additional hoses that lead to the water pump cover, as shown in the video.

At this point, install the new hoses, tightening the metal clip at the end, following the video tutorial until the end!


Posted on 21 May 2026 by ScegliAuto


Related tutorials

How to Change the Coolant on the Benelli TRK 502
How to Change the Coolant on the Benelli TRK 502
Trk 502 In this video tutorial, you will see how to bleed the cooling system and replace the coolant on a Benelli TRK 502 in simple steps. To remove the old …
How to Replace the Coolant in a Benelli TRK 502
How to Replace the Coolant in a Benelli TRK 502
Trk 502 In this brief and simple guide, you will find instructions on how to drain and top up the coolant in the Benelli TRK 502 motorcycle. First, place you…
How do you replace the coolant of the Benelli TRK 502?
How do you replace the coolant of the Benelli TRK 502?
Trk 502 It will be possible to replace the coolant of the Benelli TRK 502 by widening the ring that connects the sleeve for the passage of the liquid to the …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos