Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Sprocket on a Benelli TRK 502?

Model: Benelli Trk 502
Part: Checks and maintenance

Video tutorial

To replace the sprocket on a Benelli TRK 502, first remove the bolts securing the sprocket cover using a Torx key. Next, use a screwdriver to pry and lift the retaining ring of the sprocket. Before removing it, you must hold the rear wheel of the motorcycle or remove it completely.

Once removed, you can loosen the chain and then replace the old sprocket with a new one: ensure that the chain is long enough for the new sprocket. At this point, simply reassemble all the previously removed parts.


Updated on 19 April 2026 by ScegliAuto


Related tutorials

How to Reset the Engine Light on a Benelli TRK 502
How to Reset the Engine Light on a Benelli TRK 502
Trk 502 Before you can begin, sit on the seat of your Benelli TRK 502. Start by setting the engine start switch to the active position. Then, fully rotate an…
How to replace the engine oil in the Benelli TRK 502 X?
How to replace the engine oil in the Benelli TRK 502 X?
Trk 502 In this tutorial we can see how to replace the engine oil in the Benelli TRK 502 X, an extremely simple and quick operation. First of all, we wait fo…
Replacing Handlebars on Benelli TRK 502
Replacing Handlebars on Benelli TRK 502
Trk 502 In this tutorial video, follow the steps to remove and replace the handlebars on a Benelli TRK 502. First, use an Allen key to unscrew the screws on …

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos