Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil on the Beta Xtrainer?

Model: Beta Xtrainer
Part: Engine oil

Video tutorial

You can change the engine oil on the Beta Xtrainer by unscrewing the drain plug from the oil sump located at the lower central part of the bike: once removed, allow all the used oil to flow into a suitably placed container. You can also remove the oil filter from the same position to replace it with a new one. At this point, proceed with topping up: pour the necessary amount of oil through the breather on the right side.


Posted on 17 June 2026 by ScegliAuto


Related tutorials

How do you replace the motor oil in the Beta Xtrainer?
How do you replace the motor oil in the Beta Xtrainer?
Xtrainer To perform the oil change on the Beta Xtrainer's motor oil, you need to loosen the drain plug located in the central bottom part of the vehicle: once…
How to Change the Engine Oil on a Beta Xtrainer
How to Change the Engine Oil on a Beta Xtrainer
Xtrainer To change the engine oil on the Beta Xtrainer, loosen the drain plug located at the bottom of the bike in the central position. Unscrewing this plug …
How to Change the Engine Oil of the Beta Xtrainer 300
How to Change the Engine Oil of the Beta Xtrainer 300
Xtrainer To change the engine oil of the Beta Xtrainer 300, loosen the screws securing the skid plate located at the bottom of the bike. Once removed, you wil…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos