Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil of the Beta Xtrainer 300

Model: Beta Xtrainer
Part: Engine oil

Video tutorial

To change the engine oil of the Beta Xtrainer 300, loosen the screws securing the skid plate located at the bottom of the bike. Once removed, you will have access to the components underneath, including the oil drain plug.

This must be unscrewed to collect the used oil in an appropriately positioned container. You can also replace the oil filter and then refit the skid plate.

Finally, top up the oil through the designated breather on the right side of the bike.


Updated on 22 May 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil in a Beta Xtrainer 300?
How to Change the Engine Oil in a Beta Xtrainer 300?
Xtrainer In this tutorial, we will see how to change the engine oil in the Beta Xtrainer 300, an extremely simple and quick operation. First, ensure that the …
How to Change the Engine Oil on the Beta Xtrainer?
How to Change the Engine Oil on the Beta Xtrainer?
Xtrainer You can change the engine oil on the Beta Xtrainer by unscrewing the drain plug from the oil sump located at the lower central part of the bike: once…
How to Replace the Gear Oil in the Beta Xtrainer 300
How to Replace the Gear Oil in the Beta Xtrainer 300
Xtrainer In today's procedure, we will see how to perform routine maintenance by replacing the transmission oil in the Beta Xtrainer 300 enduro bike. First, p…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos