Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Restoring the Exhaust on a Beta RR 50

Model: Beta Rr 50
Part: Exhaust muffler

Video tutorial

To remove the exhaust, take off the springs between the cylinder and the exhaust itself, using a wire and pulling them with pliers. There are two springs.

As shown in the video, unscrew the two bolts. Now it will take some force, but the exhaust will come off, sliding out from the back.

Sand the exhaust, initially with coarser sandpaper (180 grit recommended) and then with finer sandpaper to remove any marks left by the first (120 grit). Using a blowtorch, rework the welds on the exhaust while holding it in a vice, being careful not to scratch it. Refit the exhaust.


Updated on 29 March 2026 by ScegliAuto


Related tutorials

Restoration and Maintenance of the Beta RR 50 Exhaust
Restoration and Maintenance of the Beta RR 50 Exhaust
Rr 50 Before starting this maintenance operation (as should normally be done), place your motorcycle in a stable and secure position. In this case, put it …
Removing the Exhaust on Beta 50 RR
Removing the Exhaust on Beta 50 RR
Rr 50 In this video, follow the main instructions to remove the exhaust from the Beta 50 RR motorcycle, allowing for its restoration by following these sim…
How to replace the exhaust on the Beta RR 50?
Rr 50 To replace the exhaust on the Beta RR 50, you need to loosen the screws that secure the side panel on the right side of the bike, at the rear. Once t…

How to Change the Engine Oil in the Triumph Tiger 1200 Rally Explorer

In this tutorial, you will see how to change the engine oil in the Triumph Tiger 1200 Rally Explorer, a very simple and quick operation. First, ensure that the engine is cool enough, then remove the lower protective cover, locate the drain hole bolt, and unscrew it using a 7mm hex key. Allow all the oil in the system to drain, unscrew the old filter, and tighten both the replacement and the bolt. At this point, simply pour the necessary amount of oil through the designated upper hole.

Watch the video!


by ScegliAuto

More videos