Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Beta 350
Part: Alternator

First, unscrew the bolt related to the gear lever using an 8 mm spanner and remove it. Disconnect the duct leading to the stator box by loosening the clamp or removing the pin. At this point, manually unscrew the oil cap, then unscrew the numerous bolts that secure the box. Open the box by removing the cover. This work is especially useful for replacing the gaskets, so obtain new gaskets once you decide to open this compartment. Proceed in reverse order until complete reassembly, and you're done.

Updated on 3 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Clutch on a Beta 350?
How to Replace the Clutch on a Beta 350?
350 To replace the clutch on a Beta 350, loosen the screws securing the side casing of the motorcycle near the kickstart lever. Once the casing is remove…
Engine Oil and Filter Replacement on a Beta 350
Engine Oil and Filter Replacement on a Beta 350
350 Engine oil and filter replacement on a Beta 350. Follow this guide to perform the replacement. Position your motorcycle on the original stand; remove…
How to do maintenance on the engine of Beta 350RR
How to do maintenance on the engine of Beta 350RR
350 Internal engine cleaning: use a specific additive for internal engine cleaning. Engine oil change: replace the engine oil with a high-quality product…

How to Replace the Front Brake Pads on a Yamaha MT-125

Follow these steps to remove and replace the front brake pads on the Yamaha MT-125. First, place the motorcycle on a stand and begin unscrewing the bolts securing the front brake caliper to remove it from the disc. Next, remove the brake pads inside by pressing the piston to retract it, as shown in the video. Clean the caliper of any residual dirt, then install the new high-quality pads; reassemble the braking system!

Watch the video!


by ScegliAuto

More videos