Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install a New Tailpiece and Number Plate Holder on the Beta RR 390

Model: Beta Rr 390
Part:

Video tutorial

This guide provides instructions for installing a new rear tailpiece, along with the number plate holder and light, on the Beta RR 390. First, place your motorcycle on a stand and begin unscrewing the fixing screws of the number plate holder and tailpiece, located at the bottom; then disconnect the electrical connectors of the light bulbs, as shown in the video.

At this point, remove the number plate holder from the tailpiece and install it onto the new one, also replacing the light; finally, secure everything properly, following the video tutorial to the end!


Updated on 13 August 2026 by ScegliAuto


Related tutorials

How do you replace the fork of the Beta RR 390?
How do you replace the fork of the Beta RR 390?
Rr 390 In order to replace the fork of the Beta RR 390, it is necessary to completely remove the front wheel of the vehicle: to do this, you will need to lo…
How to Replace the Radiator on the Beta RR 390?
How to Replace the Radiator on the Beta RR 390?
Rr 390 To replace the radiator on the Beta RR 390, first loosen the drain cap of the reservoir containing the coolant: this is located on the left side of t…
How do you replace the spark plug on the Beta RR 390?
How do you replace the spark plug on the Beta RR 390?
Rr 390 To replace the spark plug of the Beta RR 390, you need to loosen the screws that secure the motorcycle seat to its housing: these screws can be found…

How to Change the Engine Oil in a Suzuki DR 350?

In this tutorial, you will see how to change the engine oil in a Suzuki DR 350, a very simple and quick operation. First, wait until the engine is cold enough, then remove the protective frame located at the bottom. Next, position a container underneath the bike, disconnect the indicated hose, and let all the oil in the system drain out. Then, open the filter housing by unscrewing the three bolts with an 8mm spanner, remove the old filter, and insert the replacement. At this point, you can reassemble everything and pour in the new oil through the designated hole.

Watch the video!


by ScegliAuto

More videos