Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Gear Oil on the Beta Xtrainer?

Model: Beta Xtrainer
Part: Transmission fluid

Video tutorial

To change the gear oil on the Beta Xtrainer, loosen the drain plug on the transmission casing, located at the lower rear of the bike. Once this plug is removed, collect the used oil in a suitably positioned container.

After all the oil has drained out, close the drain plug and top up the oil: this can be done by adding the necessary amount of oil through the breather located on the right side of the vehicle.


Updated on 31 August 2026 by ScegliAuto


Related tutorials

How to Replace the Gear Oil in the Beta Xtrainer 300
How to Replace the Gear Oil in the Beta Xtrainer 300
Xtrainer In today's procedure, we will see how to perform routine maintenance by replacing the transmission oil in the Beta Xtrainer 300 enduro bike. First, p…
How to Change the Engine Oil on a Beta Xtrainer
How to Change the Engine Oil on a Beta Xtrainer
Xtrainer To change the engine oil on the Beta Xtrainer, loosen the drain plug located at the bottom of the bike in the central position. Unscrewing this plug …
How do you replace the motor oil in the Beta Xtrainer?
How do you replace the motor oil in the Beta Xtrainer?
Xtrainer To perform the oil change on the Beta Xtrainer's motor oil, you need to loosen the drain plug located in the central bottom part of the vehicle: once…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos