Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Dismantle the Engine of the Beta RR 350?

Model: Beta Rr 350
Part: Engine

Video tutorial

To dismantle the engine of the Beta RR 350, loosen the bolts securing the engine block within its housing. Once the engine block is freed, you can extract it from its position by disconnecting all the relevant sensor connectors.

Next, remove the cylinder and detach the piston from the corresponding conrod. Now, you can remove the side casings of the engine by loosening the screws and extracting the components inside.

These can then be replaced with new spare parts, reassembling all the engine components.


Updated on 7 September 2026 by ScegliAuto


Related tutorials

How to Replace the Engine Oil and Oil Filter on the Beta RR 350
How to Replace the Engine Oil and Oil Filter on the Beta RR 350
Rr 350 Today, you will see the necessary steps to replace the engine oil and oil filter while performing routine maintenance on the Beta RR 350 motorcycle. …
How to Service the Beta RR 350
How to Service the Beta RR 350
Rr 350 This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bi…
How to Remove the Engine Oil from a Beta RR 350
How to Remove the Engine Oil from a Beta RR 350
Rr 350 Before you begin, run the engine of your Beta RR 350 for a few minutes, then position it on the side stand. Start by removing the lower cover that pr…

How to Change the Engine Oil in a Suzuki DR 350?

In this tutorial, you will see how to change the engine oil in a Suzuki DR 350, a very simple and quick operation. First, wait until the engine is cold enough, then remove the protective frame located at the bottom. Next, position a container underneath the bike, disconnect the indicated hose, and let all the oil in the system drain out. Then, open the filter housing by unscrewing the three bolts with an 8mm spanner, remove the old filter, and insert the replacement. At this point, you can reassemble everything and pour in the new oil through the designated hole.

Watch the video!


by ScegliAuto

More videos