Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Bmw R 1200 Gs
Part: Air filter

Remove the original engine air filter on a BMW R1200GS. Follow this guide video for the replacement procedure. Position the motorcycle on a centre stand, remove the side panels (right side); take off the fuel tank plastics. Using a screwdriver, unscrew the securing screws of the housing, uncover the cap, and remove the air filter. Place a new one if damaged or reposition the same after cleaning it (use an air compressor). Finally, close the air filter housing, and refit the removed panels over the right side of the tank.

Updated on 9 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery on a BMW R1200GS?
How to Replace the Battery on a BMW R1200GS?
R 1200 Gs To replace the battery on the BMW R1200GS, first remove the plastic cover of the frame, which is held in place by three elastics. Once this is done, …
Replacing Air Filter on BMW R 1200 GS
Replacing Air Filter on BMW R 1200 GS
R 1200 Gs In this video, you will see how to disassemble and replace the air filter of a BMW R 1200 GS, following these instructions. First, remove the plastic…
How to Replace the Air Filter on the BMW R 1200 GS?
How to Replace the Air Filter on the BMW R 1200 GS?
R 1200 Gs To replace the air filter on the BMW R 1200 GS, you need to lift the glove box located just above the fuel cap and directly below the steering wheel.…

Guide to replacing the starter motor of the Piaggio Vespa ET4 150

Today's guide will show us how to disassemble and replace the starter motor of the Piaggio Vespa ET4 150 scooter, in simple steps. First, we put the scooter on the center stand and lift the seat; we remove the battery, disconnecting both terminals, and then remove the compartment under the seat, as shown in the video. At this point, we disconnect the intake hose to access the starter motor, unscrewing its fastening screws and disconnecting the wiring to remove it; all that's left is to replace it with the new original one, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos