Do it yourself
Frequently asked questions about cars and motorcycles

Model: Bmw R1200gs
Part:

To remove the grips on a BMW R1200GS, first remove the hand guards by unscrewing the bar ends and the fastening screws of the hand guards. Once removed, cut off the old grips with a utility knife, being careful not to apply too much pressure, as this could damage the heating element. Next, clean with some alcohol to remove any rubber residue. At this point, by pouring a bit of oil inside the new grips, you will be able to fit them. Finally, reattach the bar ends and remount the screws and hand guards.

Updated on 19 April 2026 by ScegliAuto

Video tutorial

Related tutorials

R1200gs Follow these instructions to remove and replace the battery of the BMW R1200GS enduro motorcycle. First, place your bike on the stand and start by re…
R1200gs Before you can start, position your BMW R1200GS on the centre stand. Begin by loosening and removing the central nut that secures the rear wheel to t…
R1200gs If your BMW R1200GS key has suddenly stopped working, it is likely time to replace the battery inside the cover. Below are the steps to follow. First…

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos