Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

BMW Z3 gear knob replacement

Model: BMW Z3 MK 1 - Years 1995-2002
Part: Shift knob

In this video tutorial we will see how to remove the gear knob, together with its boot, on a BMW Z3. First of all we get inside the car and we go to unhook the gearshift gaiter; after which we remove our knob, pulling strongly upwards, as shown in the video. If it does not come out easily we can opt to cut it; after which we go to replace, if desired, the gearshift gaiter together with the new knob. To insert it correctly, let's apply a clamp between the cap and the knob or otherwise apply a sealant that holds it in place!

Posted on 26 December 2020 by ScegliAuto

Video tutorial

Related tutorials

How to replace the gear knob of the BMW Z3
How to replace the gear knob of the BMW Z3
BMW Z3 (1995-2002 / MK 1) If you own a BMW Z3 and the gear knob is too worn out, then you have no choice but to replace it with a new one. In the following guide, we will desc…
How do you remove the rear cover of the speedometer from the BMW Z3?
How do you remove the rear cover of the speedometer from the BMW Z3?
BMW Z3 (1995-2002 / MK 1) In order to replace the rear cover of the BMW Z3, you must first remove the speedometer from inside its housing, unscrewing the special screws and di…
How to replace the exterior door handle of the front door of the BMW Z3.
How to replace the exterior door handle of the front door of the BMW Z3.
BMW Z3 (1995-2002 / MK 1) Today's instructions will illustrate the procedure for disassembling and replacing the external door handle of the BMW Z3. First, let's open the fron…

How to Install Roof Bars on a Fiat 500L

Learn how to fit universal roof bars on a Fiat 500L. These bars are used on vehicles with or without roof rails. Assemble the roof bar kit (as shown in the video) with bars adjusted to the width of the vehicle (measure with a tape measure). Position the brackets at both ends of the doors on the vehicle's original roof rails. Once the anchoring bracket width is set, tighten the bolts with a butterfly nut (if a lock is present) until fully secured to the roof rails. Fit safety caps on both sides.

Watch the video!


by ScegliAuto

More videos