Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Replacing Spark Plugs

Model: BMW Serie 5 E39 - Years 1995-2003
Part: Spark plugs

It is recommended to perform this maintenance with a cold engine to avoid unpleasant burns; start by disconnecting the locking tab of the connector attached to the ignition coil, then unscrew the mounting screw of the coil itself and remove it along with the boot; before unscrewing the spark plug, it is advisable to blow compressed air into the spark plug hole to eliminate any debris that could fall into the cylinder during disassembly; then remove the old spark plug and install the new one by first hand-tightening it and then tightening it with the wrench without exceeding the torque; reposition the boot with the coil and reconnect the connector.

Updated on 17 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the spark plugs of the BMW 5 Series 550i
Replacement of the spark plugs of the BMW 5 Series 550i
BMW Serie 5 (2010-2017 / F10, F11) Today's step-by-step instructions will show us how to disassemble and replace the spark plugs and ignition coils of the BMW 5 Series 550i, with a V8 …
BMW 5 Series spark plug replacement
BMW 5 Series spark plug replacement
BMW Serie 5 (2003-2010 / E60, E61) Raise the hood. First remove the air filter box by unscrewing the 13 mm bolts. Disconnect the sensor connected to the other box, the one on the right…
Replacing the spark plugs on the BMW 5 Series F10 2.0 Twin Turbo
Replacing the spark plugs on the BMW 5 Series F10 2.0 Twin Turbo
BMW Serie 5 (2010-2017 / F10, F11) Today we will see, in this video tutorial, how to remove and replace the engine spark plugs on the BMW 5 Series F10, with 2.0 Twin Turbo engine (code…

Other guides you may be interested in

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos