Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 5
    4. : Disassembly of the rear bench and floor to install the speakers

BMW Serie 5 - Video tutorial

Model: BMW Serie 5 E39 - Years 1995-2003
Part: Rear bench seat
Operation: Disassembly of the rear bench and floor to install the speakers

Lift and remove the rear head restraints. Remove the hook covers and remove the side ceiling light. Unscrew the two screws holding the skirt on the upright and remove it. Carry out the same operation on the other upright as well. With a wrench, remove the hook nuts and remove them. Remove the seat of the seat and unscrew the screws holding the seat back and remove it. Same operation with the other backrest. Use a mat placed on the ground so as not to injure yourself with the protruding hooks. Unscrew the rear cover screws and remove the plastic plugs. Remove the cover. Remove the screws holding the floor and extract it by pulling it inwards, paying attention to the seat belts.


Posted on 23 June 2023 by ScegliAuto



How to remove rear seats from BMW 5 Series
BMW Serie 5 (1988-1995 / E34) Today's guide will show us how to disassemble and replace the rear seats of the BMW 5 Series, in simple and quick steps. First of all, we open the re
How to disassemble the speakers in the BMW 5 Series?
BMW Serie 5 (2010-2017 / F11, F10) In this tutorial we can see how to replace the speakers in the BMW 5 Series, an extremely simple and quick operation. First of all, make sure that th
Transmission shaft flanges replacement
BMW Serie 5 (1995-2003 / E39) The failure of the rubber flexible coupling flange applied at the two cardan joints (front and rear) of the transmission shaft that connects the gear

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos