Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Cadillac Xt5 - Engine oil

Cadillac Xt5 (2017-2024 / MK 1)
How to replace the oil, oil filter, and reset the service light on a Cadillac XT5.
To replace the oil and oil filter of the Cadillac Xt5, lift the front of the car (a lift bridge was used in the video, but lifting the front is also …read all…
Posted on 19 April 2023 by ScegliAuto
Cadillac Xt5 (2017-2024 / MK 1)
How to change the oil in a Cadillac Xt6?
The replacement of the motor oil must be done with the car lifted on a bridge or on stands and with the engine cold. Position yourself under the car, bringing …read all…
Posted on 2 April 2023 by ScegliAuto
Cadillac Xt5 (2017-2024 / MK 1)
How to change the engine oil in the Cadillac XT5
In this new guide we will describe all the various steps necessary to be able to perform the engine oil change correctly and safely on your Cadillac XT5. …read all…
Posted on 11 May 2024 by ScegliAuto
Battery (1) Bodywork (1) Key (1) -board computer (2) Checks and maintenance (6) Tail light (2) Air filter (1) Cabin air filter (3) Light bulb (1) Rear light bulb (2) Handle (1) Engine oil (3) Door panel (1) Front bumper (1) Brake pads (1) Door (1) Instrument cluster (1) Fuse box (1) Steering wheel (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos