Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Window Regulator Motor on Citroen C4

Model: Citroen C4 MK 1 - Years 2004-2010
Part: Power window motor

To access the window regulator motor, you must first remove the door panel. This is shown in other tutorials, but the removal is quite simple and similar across all cars: locate all the bolts securing it, which may be under the door, on the side at the handle height, near the internal handle, and close to the window switch (in the last two cases, they will be covered by plastic trim). Once done, you can remove the panel and move on to the motor: remove the three Torx screws securing it to the door, then unscrew the Torx from the bracket under the glass and disassemble everything.

Updated on 10 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Inner Door Panel of a Citroen C4 MK1
How to Remove the Inner Door Panel of a Citroen C4 MK1
Citroen C4 (2004-2010 / MK 1) Let's see how to remove the inner door panel of the front door of a Citroen C4 MK1: start by removing the securing screws. One is located under the r…
How to dismantle the interior panel of the door, in the Citroen C4 2?
How to dismantle the interior panel of the door, in the Citroen C4 2?
Citroen C4 (2010-2018 / MK 2) The video presented here shows how to disassemble the internal panel of a door on a Citroen Picasso, specifying that the operational sequence is the …
Removing the Door Panel of the Citroen C4 Cactus
Removing the Door Panel of the Citroen C4 Cactus
Citroen C4 (2014-2020 / Cactus) Here’s how to remove the front door panel of the Citroen C4 Cactus in simple steps. First, open the front door of the vehicle and start by removing t…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos