Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. C3
    4. : How to disassemble the outside rear view mirror of the Citroen C3

Citroen C3 - Video tutorial

Model: Citroen C3 SX, SY - Years 2016-2023
Part: Outside rearview mirror
Operation: How to disassemble the outside rear view mirror of the Citroen C3

Let's find out today in this guide the instructions which will allow us to disassemble and replace the outside rear view mirror of your Citroen C3. First of all, we open the front door and start disassembling and removing the door panel, unscrewing all the fixing screws; we then disconnect the electrical connector and the handle cable, as shown in the video. At this point, unscrew the fixing screws of the external rear view mirror, disconnecting the wiring to remove it; Let's install the new rear view mirror and finally put the door panel back!


Posted on 29 May 2023 by ScegliAuto

    Frequently Asked Questions

    • C3 2016-2023 - Why does the exterior mirror of the Citroen C3 not close? Read Answer
    • C3 2009-2016 - How to disassemble the body of the electric mirror of the Citroen C3? Read Answer
    • C3 2016-2023 - Why does the exterior mirror of the Citroà «n C3 not work? Read Answer
    • C3 2002-2009 - Where is the external temperature sensor of the Citroen C3? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos