Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Dacia
    3. :
  3. Sandero
    4. : How to install high beam leds in a Dacia Sandero.

Dacia Sandero - Video tutorial

Model: Dacia Sandero MK 3 - Years 2021-2024
Part: Headlight bulb
Operation: How to install high beam leds in a Dacia Sandero.

In this video tutorial we can see how high beam LEDs can be installed in a Dacia Sandero by following a few simple steps: the first thing to do is to buy the LED bulbs at an authorized car spare parts dealer. Get into the car, turn off the car and apply the handbrake. Lift the bonnet and secure it with the appropriate rod. Remove the ring from the LED bulb (assemble it before inserting the LED bulb in its housing). Insert the male and female extension cables (as shown in the video) into the led bulb, to connect the connector. Join the trolley to the lamp holder before inserting it (to make the bulb slide better during insertion, you can use a silicone grease). Remove the bulb cover, remove the clip that holds the bulb, pulling it upwards, extract the bulb, and insert the lamp holder ring in its seat, (if you fail, you can insert the bulb with the ring and the trolley together, to work less); connect the connectors to the bulb and then insert the bulb. Replace the bulb cover. Do the same job on the other side as well.


Posted on 17 April 2023 by ScegliAuto

    Frequently Asked Questions

    • Sandero 2012-2020 - Why don't the blinding lights of the Dacia Sandero work? Read Answer
    • Sandero 2008-2012 - How to replace the low beam bulbs on the Dacia Sandero? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos