Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on a Derbi GPR 50?

Model: Derbi Gpr 50
Part: Service warning light

Video tutorial

To reset the Service light on a Derbi GPR 50, turn on the instrument panel by turning the key in the ignition switch: once the panel is on, access the menu by holding down the MODE button next to the panel. This will bring up the screen where you can navigate using single presses of the same button; when the maintenance option appears, hold down the MODE button again until the reset is complete.

After the operation, you can turn off the panel.


Updated on 18 September 2026 by ScegliAuto


Related tutorials

How do you replace the stator of the Derbi GPR 50?
How do you replace the stator of the Derbi GPR 50?
Gpr 50 To replace the stator of the Derbi GPR 50, you will need to loosen the screws that secure the cover of the component, which will be located on the le…
How to Replace the Exhaust on a Derbi GPR 50?
How to Replace the Exhaust on a Derbi GPR 50?
Gpr 50 To replace the exhaust on the Derbi GPR 50, loosen the screws that secure the exhaust end can to the supports. Once the old exhaust is freed from its…
How to Replace the Coolant on a Derbi GPR 50
How to Replace the Coolant on a Derbi GPR 50
Gpr 50 This guide will show you how to drain and replace the coolant in the engine of the Derbi GPR 50 motorcycle. First, place the motorcycle on a stand, e…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos