Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Dodge
    3. :
  3. Caliber
    4. : Drive shaft replacement instructions

Dodge Caliber - Video tutorial

Model: Dodge Caliber MK 1 - Years 2006-2012
Part: Drive shaft
Operation: Drive shaft replacement instructions

Once the car has been raised on a lift, remove the wheel, remove the safety pin placed to protect the nut fixing the drive shaft to the hub and unscrew the nut itself. Then unscrew the fixing pin of the oscillating arm head to the hub and extract it from this seat; then extract the drive shaft from the hub and then from the gearbox by levering it in correspondence with the joint itself (oil could leak out of the gearbox). Then insert the new semi-shaft first from the gearbox side, pressing it until it fits and then into the hub, finally tightening the pins previously removed. Top up the gearbox oil level (the plug is located right next to the drive shaft.


Posted on 31 July 2023 by ScegliAuto



Demonstration of disassembly of the drive shaft
Dodge Caliber (2006-2012 / MK 1) To disassemble the axle shaft you must first lift the car with the jack and place stands in compliance with safety regulations. Remove the wheel. Rem
Arm removal and replacement
Dodge Caliber (2006-2012 / MK 1) This video shows us how to remove and replace the arm of our car. When we drive on roads with holes or with uneven pavement and we hear a strange noi
Battery replacement instructions
Dodge Caliber (2006-2012 / MK 1) Replacing the battery is a typical do-it-yourself maintenance, especially when it is housed in a very easy to reach position, as in the case of the v

Other guides that may interest you

How do you replace the horn on the Citroà «n Berlingo?

In order to replace the horn on the Citroà «n Berlingo, the vehicle must be raised so that the screws that secure the left front wheel can be loosened and removed completely. Once this wheel has been removed, it will be possible to access the screws that secure the internal cover of the corresponding wheel arch: this will have to be detached and it will be possible to access the components inside, including the horn. This will need to be disconnected from its connector and removed from its holders, so that it can be replaced with a new spare part.

Watch the video!


by ScegliAuto

More videos