Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Headlamp Bulb

Model: Dodge Caliber MK 1 - Years 2006-2012
Part: Headlight bulb

To access the bulb holder of the left front headlamp (driver's side), first remove the plastic cover above the battery compartment; then, disconnect the bulb holder while keeping the connector attached, turning it anti-clockwise; next, extract the locking clip from the connector and disconnect it from the bulb, which is complete with bulb holder; then connect the new bulb to the connector, also inserting the locking clip, and install it on the headlamp, ensuring it clicks into place; proceed in the same way to replace the same bulb in the other headlamp.

Updated on 16 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the front headlight bulb of the Dodge Caliber.
How to replace the front headlight bulb of the Dodge Caliber.
Dodge Caliber (2006-2012 / MK 1) This guide will briefly explain the steps that will allow us to disassemble and replace the headlight bulb of the Dodge Caliber. First, we open the c…
Front Headlamp Bulb Replacement
Front Headlamp Bulb Replacement
Dodge Caliber (2006-2012 / MK 1) To replace the front headlamp bulb (H13 fitting), open the bonnet and remove the plastic cover from the battery compartment. Disconnect one battery t…
Replacing the Rear Car Headlamp
Replacing the Rear Car Headlamp
Dodge Caliber (2006-2012 / MK 1) The following guide shows how to correctly change the rear headlamp of your car without necessarily resorting to a mechanic and spending more than yo…

Other guides you may be interested in

How to Remove the Engine Oil Filter of the Peugeot 308

How do you remove the engine oil filter of the Peugeot 308? Follow this guide to proceed with the replacement. Open the car door and pull up the engine compartment release lever located at the bottom left of the dashboard, then lift the front bonnet and secure it. Using a socket wrench, unscrew the large securing bolt of the container cap where the oil filter is located (engine compartment under the ventilation pipe). Drain the used oil from under the engine sump. Remove the worn oil filter and position a new one, ensuring it adheres well around the walls of the housing. Finally, refit the ventilation pipe and top up the engine oil. Close the front bonnet last.

Watch the video!


by ScegliAuto

More videos