Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removal and Replacement of the Front Wheel Arch Liner

Model: Dodge Charger LX - Years 2006-2011
Part: Body

Lift the car at the location of the wheel arch to be removed. Remove the tyre. Now, disconnect the brake cable and remove the six plastic clips holding the inner arch liner in place using a plastic lever. Secure and remove the four outermost rivets using the appropriate tool. At this point, you can remove the plastic inner liner starting from one side and pulling it out towards the other side. Fit the new liner by repeating the same operations, but in reverse order. The car on which the maintenance operation was performed is a Dodge Charger.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Front Bumper Removal Instructions
Front Bumper Removal Instructions
Dodge Charger (2006-2011 / LX) To comfortably remove the front bumper, it is recommended to lift the vehicle on suitable axle stands and remove the front wheels, as the plastic whe…
Disassembling the Windscreen Wiper Mechanism
Disassembling the Windscreen Wiper Mechanism
Dodge Charger (2006-2011 / LX) The wiper motor mechanism consists of a motor and a lever system that rotates the wipers. This mechanism is located beneath the plastic cover directl…
Replacing the Rear Headlamp Bulb
Replacing the Rear Headlamp Bulb
Dodge Charger (2006-2011 / LX) Replacing the rear headlamp bulbs is straightforward, as disassembling the headlamp itself is also quite simple. Open the rear bonnet and locate the …

How to Replace the Fuel Pump on an Opel Corsa C

Usually, upon the first ignition of the dashboard, a sound similar to a spray can be heard from the rear of the cabin: this is the fuel pump pressurising the system and preparing to supply fuel to the engine for ignition; if this sound is not heard, start by checking the integrity of the relevant power fuse, and if it is intact, verify that voltage reaches the power connector; if current is present, you can also try powering the pump directly to confirm it is faulty; replacing it is very simple, just disconnect the connector and hoses, then unclip the retaining ring and remove it to replace it with a new one.

Watch the video!


by ScegliAuto

More videos