Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Engine Oil and Filter on the Ducati 999

Model: Ducati 999
Part: Engine oil

Video tutorial

This guide shows how to replace the engine oil on the Ducati 999. If you have race stands, you can use those as well. Start the bike to warm up the oil and remove the right fairing by detaching the clips and securing bolts.

Position a container under the oil sump for fluid disposal and unscrew the drain bolt; also unscrew the oil filler cap. Unscrew the four screws of the mesh filter and empty it; take care with the gasket of the cap. Detach the mesh filter from its housing, being careful not to break it; clean it well before refitting.

Unscrew the oil filter and let the fluid drain.

Refit the filters in position after lubricating the gaskets and top up the tank. Run the engine for a few minutes and then check the oil level.


Updated on 28 May 2026 by ScegliAuto


Related tutorials

How to Replace the ECU on the Ducati 999/749
How to Replace the ECU on the Ducati 999/749
999 In this tutorial, learn how to remove and replace the engine ECU on the Ducati 999, as well as the 749. First, locate the ECU behind the cooling radi…
How to replace the headlight bulb in the Ducati 999?
How to replace the headlight bulb in the Ducati 999?
999 In this tutorial we can see how to replace the headlight bulb in the Ducati 999, an extremely simple and quick operation. First of all, make sure tha…
How to Replace the Rear Brake Pads on a Ducati 999
How to Replace the Rear Brake Pads on a Ducati 999
999 To replace the rear brake pads on a Ducati 999, loosen the screws that secure the rear brake caliper to the corresponding disc, allowing you to compl…

How to Dismantle the Engine of the TM Racing MX 125?

To dismantle the engine of the TM Racing MX 125, loosen the screws securing the side casing of the bike so that it can be removed, providing access to the clutch. Next, remove the spark plug from the top of the cylinder, then loosen the screws securing the cylinder as well: after removing the cylinder, you will be able to locate the piston underneath, which must be freed from the conrod by expanding its retaining ring. At this point, all further components within the engine block can be removed and replaced with new ones.

Watch the video!


by ScegliAuto

More videos