Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Resistor in a Fiat Punto

Model: Fiat Punto MK 2, 188 - Years 1999-2011
Part: Blower motor

Where is the blower motor resistor located in a Fiat Punto? This video shows how to perform the disassembly. Use a lever to remove the plastic cover under the dashboard, then unscrew the cover (where the resistor is located) with a screwdriver. Disconnect the resistor, then extract it from the cabin. Insert the new blower motor resistor (connect the power connector). Finally, reattach the cover under the dashboard. Check the correct installation of the previously fitted parts and test their proper functioning.

Updated on 14 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Heater Fan Resistor on Fiat Grande Punto
Replacing the Heater Fan Resistor on Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Want to remove the heater fan resistor on a Fiat Grande Punto? Let's see how to disassemble the fan resistor. Remove the plastic cover from under the…
How to Replace the Fan Resistor on a Fiat Grande Punto
How to Replace the Fan Resistor on a Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) How to replace the fan resistor on a Fiat Grande Punto? Here’s how to carry out the replacement. Use a lever to remove the plastic under the front wi…
How to Replace the Cabin Fan Resistor of a Fiat Grande Punto
How to Replace the Cabin Fan Resistor of a Fiat Grande Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Below we will see the procedure to remove and replace the cabin fan resistor of a Fiat Grande Punto. First, get inside the vehicle on the front passe…

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos