Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Bleed and Replace the Radiator Fluid on Fiat Panda 169 1.2 Petrol

Model: Fiat Panda 169, MK 2 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Antifreeze coolant

See other generations:
Video tutorial

Follow these steps to bleed and replace the radiator fluid on a Fiat Panda 169 second series, with a 1.2 petrol engine. First, open the bonnet of your car and locate the radiator bleed screw, which is found at the top near the passenger side; once you have removed all the old fluid, fully tighten the screw before adding new radiator fluid to the designated reservoir, as shown in the video.

Finally, fill to the maximum level indicated by a mark on the reservoir!


Updated on 7 April 2026 by ScegliAuto


Related tutorials

Replacing the Radiator and Air Conditioning Pipes on the Fiat Panda
Replacing the Radiator and Air Conditioning Pipes on the Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Today, let's see how to dismantle and replace the radiator and air conditioning pipes on the Fiat Panda. First, open the bonnet and begin to remove t…
How to Replace the Radiator Fluid on a Panda
How to Replace the Radiator Fluid on a Panda
Fiat Panda (2003-2012 / 169, MK 2) Is the radiator fluid due for replacement? Let’s look at draining the coolant on a Panda. Lift the car on a jack, disconnect the radiator hose at the…
How to Replace the Heater Radiator in a Fiat Panda
How to Replace the Heater Radiator in a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) In this brief guide, you will learn how to remove and replace the heater radiator in a Fiat Panda. First, get inside the vehicle and start by removin…

    Frequently Asked Questions

    • Panda 2003-2012 - Where are the water bleed valves of the Fiat Panda? Read answer

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos