|
Do it yourself
| |||
| ||||
Brake Pad Replacement on Fiat Multipla
Model: Fiat Multipla
MK 1
- Years:
1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Video tutorial
Remove the small central cover from the wheel of interest and loosen the bolts. Lift the car and finish unscrewing the aforementioned bolts until you can remove the wheel. Unscrew the two rear bolts of the brake caliper, as shown in the video, and take it out. If you do not need to replace the disc (as shown in the video), you can already change the pads by removing the worn ones and inserting the new ones. Be careful as the new pads will obviously be thicker, and you may need to leverage the caliper with a large flat screwdriver to fit them in. Refit the caliper and screw it back on.
Updated on 9 April 2026 by ScegliAuto
Related tutorials
Fiat Multipla
(1998-2010 /
MK 1)
If you own a Fiat Multipla and want to locate the OBD port, carefully follow this guide and apply the described steps. First, enter your Fiat Multipl…
Fiat Multipla
(1998-2010 /
MK 1)
Before starting, open the bonnet of your Fiat Multipla by pulling the designated release handle located at the bottom left of the steering column. Be…
Fiat Multipla
(1998-2010 /
MK 1)
Today's main instructions will show us how to replace the timing belt of the Fiat Multipla 1.6 16V. First, we lift the vehicle and start by disassemb…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.
Other guides you may be interested in |
Where is the battery located on the Aprilia Scarabeo 250ie scooter?
This video shows where the battery is located on the Aprilia Scarabeo 250ie scooter and how to proceed if you need to replace it. As shown, it is located beneath the seat. To access and replace it, first open the seat, then remove the plastic cover by unscrewing the relevant screws with a cross-head screwdriver. Next, disconnect both terminals, starting with the negative, remove the battery from its housing, and install the new replacement following the reverse procedure. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.014
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy - About us VAT number: IT01247470535 |