Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove and Replace the Third Brake Light on a Fiat Panda 169

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Tail light

Today, you will see the instructions that will allow you to remove and replace the third brake light, or replace the bulbs, on a Fiat Panda 169, second series. First, open the boot and unscrew the two fixing screws located on the panel, which are for the third brake light; once removed, you can extract it from the inside, then unscrew the additional screws to separate it from the plastic. At this point, disconnect the electrical connector to proceed with replacing the bulbs or the light itself; apply the reverse procedure for reassembly!

Updated on 13 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the third brake light bulb of the Fiat Panda
How to replace the third brake light bulb of the Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) To replace the third brake light of the Fiat Panda, start by opening the trunk; once the trunk is open, you will find a cover in the center of the gl…
How to Replace the Thermostat on a Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) This video outlines all the necessary steps to replace the thermostat on a Fiat Panda 169, including how to replace the temperature sensor. By follow…
How to Replace Wiper Blades on a Fiat Panda 169
How to Replace Wiper Blades on a Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) In today's video, you will replace the front and rear wiper blades on a second-generation Fiat Panda 169 in simple steps. First, start by removing an…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos