Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replace the Rear Light Bulb on Fiat 500

Model: Fiat 500 312 - Years 2007-2021
Part: Tail light bulb

In today's guide video, you will see how to remove and replace the bulbs in the rear light of a Fiat 500. First, open the boot and remove the two side screws of the light; then take out the light and disconnect the electrical connector of the bulbs. At this point, remove the protective cover by releasing the tabs, and access all the bulbs, where you will press and twist to remove them, as shown in the video. Finally, insert the new bulbs and reassemble everything, as illustrated in the video!

Updated on 16 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Light Bulbs of a Fiat 500
Fiat 500 (2007-2024 / 312) Are the bulbs in the rear light of your Fiat 500 no longer working? Follow this guide to replace the rear light bulbs. Open the boot lid, unscrew the…
Replacing the Rear Light Bulb on a Fiat 500
Replacing the Rear Light Bulb on a Fiat 500
Fiat 500 (2007-2021 / 312) In this video tutorial, you will learn how to remove and replace the rear light bulb of a Fiat 500. First, open the boot lid and unscrew the side scr…
Fiat 500 Rear Light Replacement
Fiat 500 Rear Light Replacement
Fiat 500 (2007-2021 / 312) Let’s look at removing the rear light on the Fiat 500. Lift the tailgate that closes the boot, locate the securing screws of the light (side of the l…

    Frequently Asked Questions

    • 500 2007-2024 - How many reversing lights are there on the Fiat 500? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos