Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Light Bulbs on Fiat 500L

Model: Fiat 500 500 L - Years 2012-2023
Part: Tail light bulb

Open the boot lid and observe the wall of the boot, on the side of the affected light. You will notice a plastic cover that you need to remove by hand. After doing this, you will reach two 8 mm bolts to unscrew. Once this is done, nothing will hold the light in place, and you can pull it out and disconnect the connector. Unscrew the two cross-head screws and access the light from behind to replace any blown bulb. After replacing the affected bulb, reassemble everything in reverse order. As you can see, this is a very simple operation. Cheers!

Updated on 20 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Rear Light Bulbs on the Fiat 500L
Replacing the Rear Light Bulbs on the Fiat 500L
Fiat 500 (2012-2023 / 500 L) In this video, see how to dismantle and replace the rear light bulbs on the Fiat 500L, following the instructions below. First, open the boot of the …
Bulb Replacement on a Fiat 500
Bulb Replacement on a Fiat 500
Fiat 500 (2012-2023 / 500 L) Replacing blown bulbs? Here’s how to do it on a Fiat 500L. Lift the front bonnet of the car, locate the inspection cap of the headlamp (at the rear o…
Replacing Bulbs on a Fiat 500L
Replacing Bulbs on a Fiat 500L
Fiat 500 (2012-2023 / 500 L) Replace the non-functioning bulbs on a Fiat 500L. Open the front bonnet by pulling the lever located at the bottom right of the dashboard and secure …

    Frequently Asked Questions

    • 500 2007-2024 - How many reversing lights are there on the Fiat 500? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos